TY - CONF A1 - Unger, Wolfgang T1 - Metrology for spatially resolved chemical analysis at the micro and nanometre scales N2 - CCQM has established a framework of comparisons to demonstrate the international comparability of chemical measurements. The key point is the establishment of comparable measurements, with traceability to internationally or nationally stated references. The Surface Analysis Working Group (SAWG) has been formally founded in 2003. CCQM ratified the group as a full working group of CCQM in April 2003 with these terms of reference: - to develop pilot studies and carry out key comparisons of national measurement standards for surface and micro/nano-analysis; - to assist in identifying and establishing inter-laboratory work to improve the traceability of surface and micro/nano-analysis; - to establish and update a work plan to be adopted by CCQM; - to discuss and review the scope of the working group and to liase with other working groups related to nanotechnology. Following the 2015 meeting of the CCQM, the pilot study CCQM-P130 “WD and ED Electron Probe Micro Analysis on Au-Cu alloys” lead by BAM&NIST has been finalized. The Key Comparison K-129 “Measurement of atomic fractions in Cu(In,Ga)Se2 Films” lead by KRISS has made substantial progress and is about to be finalized. The new Key Comparison K-136 on “BET specific surface of ” lead by UNIIM&BAM has made strong progress in 2015 and will be finished in 2016. T2 - 22nd Meeting of CCQM CY - Sevres, France DA - 21.4.16 KW - Surface chemical analysis KW - Metrology PY - 2016 AN - OPUS4-35865 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -