Refine
Year of publication
- 2023 (2)
Document Type
Language
- English (2)
Keywords
- Cold Start (2)
- Gas Engines (2)
- Methane (2)
- Simulation (2)
- Alternative Fuel Engines (1)
- Carbon Monoxide (1)
- Catalysts (1)
- Co-Simulation (1)
- Detailed Chemistry (1)
- Exhaust Emissions (1)
Institute
During cold start of natural gas engines, increased methane and formaldehyde emissions can be released due to flame quenching on cold cylinder walls, misfiring and the catalyst not being fully active at low temperatures. Euro 6 legislation does not regulate methane and formaldehyde emissions. New limits for these two pollutants have been proposed by CLOVE consortium for Euro 7 scenarios. These proposals indicate tougher requirements for aftertreatment systems of natural gas engines.
In the present study, a zero-dimensional model for real-time engine-out emission prediction for transient engine cold start is presented. The model incorporates the stochastic reactor model for spark ignition engines and tabulated chemistry. The tabulated chemistry approach allows to account for the physical and chemical properties of natural gas fuels in detail by using a-priori generated laminar flame speed and combustion chemistry look-up tables. The turbulence-chemistry interaction within the combustion chamber is predicted using a K-k turbulence model. The optimum turbulence model parameters are trained by matching the experimental cylinder pressure and engine-out emissions of nine steady-state operating points.
Subsequently, the trained engine model is applied for predicting engine-out emissions of a WLTP passenger car engine cold start. The predicted engine-out emissions comprise nitrogen oxide, carbon monoxide, carbon dioxide, unburnt methane, formaldehyde, and hydrogen. The simulation results are validated by comparing to transient engine measurements at different ambient temperatures (-7°C, 0°C, 8°C and 20°C). Additionally, the sensitivity of engine-out emissions towards air-fuel-ratio (λ=1.0 and λ=1.3) and natural gas quality (H-Gas and L-Gas) is investigated.
In contrast to the currently primarily used liquid fuels (diesel and gasoline), methane (CH4) as a fuel offers a high potential for a significant reduction of greenhouse gas emissions (GHG). This advantage can only be used if tailpipe CH4 emissions are reduced to a minimum, since the GHG impact of CH4 in the atmosphere is higher than that of carbon dioxide (CO2). Three-way catalysts (TWC - stoichiometric combustion) and methane oxidation catalysts (MOC - lean combustion) can be used for post-engine CH4 oxidation. Both technologies allow for a nearly complete CH4 conversion to CO2 and water at sufficiently high exhaust temperatures (above the light-off temperature of the catalysts). However, CH4 combustion is facing a huge challenge with the planned introduction of Euro VII emissions standard, where stricter CH4 emission limits and a decrease of the cold start starting temperatures are discussed.
The aim of the present study is to develop a reliable kinetic catalyst model for MOC conversion prediction in order to optimize the catalyst design in function of engine operation conditions, by combining the outputs from the predicted transient engine simulations as inputs to the catalyst model. Model development and training has been performed using experimental engine test bench data at stoichiometric conditions as well as engine simulation data and is able to reliably predict the major emissions under a broad range of operating conditions. Cold start (-7°C and +20°C) experiments were performed for a simplified worldwide light vehicle test procedure (WLTP) driving cycle using a prototype gas engine together with a MOC. For the catalyst simulations, a 1-D catalytic converter model was used. The model includes detailed gas and surface chemistry that are computed together with catalyst heat up. In a further step, a virtual transient engine cold start cycle is combined with the MOC model to predict tail-pipe emissions at transient operating conditions. This method allows to perform detailed emission investigations in an early stage of engine prototype development.