TY - GEN A1 - Schmidt, Thomas A1 - Buß, Lars A1 - Ewert, Moritz A1 - Schönhoff, Gunnar A1 - Wehling, Tim Oliver A1 - Falta, Jens T1 - Adsorption of sulfur on Si(111) T2 - Surface Science N2 - The adsorption of S on Si(111)- 7 × 7 has been investigated for different preparation schemes and parameters. S was supplied from an electrochemical Ag2S cell. For room temperature adsorption and subsequent annealing, no ordered S induced reconstruction can be observed with spot profile analysis low-energy electron diffraction (SPALEED). S deposition at temperatures above about 400°C, however, leads to a well-ordered reconstruction. Judging from the LEED pattern, the same reconstruction was already observed by Metzner et al. [Surf. Sci. 377–379(1997) 71–74] who identified it as 4 × 4 reconstruction. The upper temperature limit for the pre-paration of this superstructure depends on S flux, which is needed to compensate for desorption. Prolonged S exposure leads to surface roughening, as observed with SPALEED and scanning tunneling microscopy (STM), pointing to surface etching by S. From our SPALEED data, we can conclude that the observed reconstruction is not a 4 × 4 reconstruction, but a 20/12 superstructure with a rectangular unit cell that exists in three rotational domains, as confirmed by STM. Different structural trial models have been assessed with density functional theory. Among these model structures, a configuration with dimers adsorbed on bridging sites, with a S coverage of 1 monolayer, is most likely, since it is energetically favorable and is in agreement with all experimental results. KW - Passivation KW - Low-energy electron diffraction KW - Scanning tunneling microscopy KW - Density functional theory KW - Auger electron spectroscopy Y1 - 2020 U6 - https://doi.org/10.1016/j.susc.2019.121561 SN - 0039-6028 SN - 1879-2758 VL - 694 ER -