TY - GEN A1 - Nitsch, Paul-G. A1 - Ratzke, Markus A1 - Pozarowska, Emilia A1 - Flege, Jan Ingo A1 - Alvarado Chavarin, Carlos A1 - Wenger, Christian A1 - Fischer, Inga Anita T1 - Deposition of reduced ceria thin films by reactive magnetron sputtering for the development of a resistive gas sensor T2 - Verhandlungen der DPG, Berlin 2024 N2 - The use of cerium oxide for hydrogen sensing is limited by the low electrical conductivity of layers deposited from a ceria target. To increase the electrical conductivity, partially reduced cerium oxide layers were obtained from a metallic cerium target by reactive magnetron sputtering. The proportions of the oxidation states Ce3+, present in reduced species, and Ce4+, present in fully oxidized species, were determined by ex-situ XPS. For electrical characterization, films were deposited on planarized tungsten finger electrodes. IV curves were measured over several days to investigate possible influences of oxygen and humidity on electrical conductivity. The morphological stability of the layers under ambient conditions was investigated by microscopical methods. The XPS results show a significant amount of Ce3+ in the layers. The electrical conductivity of as-grown samples is several orders of magnitude higher than that of samples grown from a ceria target. However, the conductivity decreases over time, indicating an oxidation of the layers. The surface morphology of the samples was found to be changing drastically within days, leading to partial delamination. KW - ceria KW - metalic cerium target KW - electrical conductivity KW - X-ray photoelectron spectroscopy (XPS) KW - oxidation states KW - morphology Y1 - 2024 UR - https://www.dpg-verhandlungen.de/year/2024/conference/berlin/part/ds/session/11/contribution/18 SN - 0420-0195 PB - Deutsche Physikalische Gesellschaft CY - Bad Honnef ER - TY - GEN A1 - Kosto, Yuliia A1 - Tschammer, Rudi A1 - Morales, Carlos A1 - Henkel, Karsten A1 - Flege, Jan Ingo A1 - Ratzke, Markus A1 - Fischer, Inga Anita A1 - Costina, Ioan A1 - Alvarado Chavarin, Carlos A1 - Wenger, Christian T1 - Rational design and development of room temperature hydrogen sensors compatible with CMOS technology: a necessary step for the coming renewable hydrogen economy T2 - Proceedings of iCampus Conference Cottbus 2024 N2 - The transition towards a new, renewable energy system based on green energy vectors, such as hydrogen, requires not only direct energy conversion and storage systems, but also the development of auxiliary components, such as highly sensitive hydrogen gas sensors integrated into mass devices that operate at ambient conditions. Despite the recent advances in nanostructured metal oxide thin films in terms of simple fabrication processes and compatibility with integrated circuits, high sensitivity, and short response/recovery times usually require the use of expensive noble metals or elevated tem-peratures (>250 ÂșC), which results in high power consumption and poor long-term stability. This article presents the first steps of the work on developing a novel resistive hydrogen gas sensor based on ultrathin cerium oxide films, compatible with complementary metal oxide semiconductor technology and capable of operating at room temperature. Here, we show a multidisciplinary bottom-up approach combining different work areas for the sensor development, such as sensor architecture, sensing mechanism and deposition strategy of the active layer, electrical contact design depending on the desired electrical output, and fast testing under controlled environments. KW - gas sensors KW - micro-structering KW - atomic layer deposition KW - sensor platform Y1 - 2024 SN - 978-3-910600-00-3 U6 - https://doi.org/10.5162/iCCC2024/P21 SP - 182 EP - 185 PB - AMA Service GmbH CY - Wunstorf ER -