TY - GEN A1 - Valkov, Stefan A1 - Kotlarski, Georgi A1 - Ormanova, Maria A1 - Doynov, Nikolay A1 - Ossenbrink, Ralf A1 - Petrov, Peter A1 - Michailov, Vesselin T1 - Crystallography and Mechanical Properties of Wire Arc Additively Manufactured Al5356 Components T2 - Comptes Rendus de L'Academie Bulgare des Sciences N2 - In this study, we present results of the evolution of the crystallographic texture and imperfections, as well as the corresponding mechanical properties of wire and arc additively manufactured (WAAM) Al5356 specimens, studied by X-ray diffraction (XRD) and tensile testing, respectively. The results show that the phase composition is in the form of a face-centred cubic (fcc) crystal structure, corresponding to the base material, as well as some traces of oxide phase Al2O3. The WAAM specimen growing is accompanied by a slight change in the preferred crystallographic orientation, from (111) to (200) and a decrease in the imperfections concentration. Also, it was found that the ultimate tensile strength (UTS), yield strength (YS), and elongation slightly decrease from the initial to the more advanced stages of growth. KW - wire arc additive manufacturing KW - Al5356 alloy KW - crystallography KW - mechanical properties Y1 - 2021 U6 - https://doi.org/10.7546/CRABS.2021.06.03 SN - 1310-1331 VL - 74 IS - No. 6 SP - 820 EP - 827 ER - TY - GEN A1 - Kotlarski, Georgi A1 - Ormanova, Maria A1 - Ossenbrink, Ralf A1 - Nikitin, Alexander A1 - Doynov, Nikolay A1 - Valkov, Stefan A1 - Michailov, Vesselin T1 - Fabrication and Characterization of Wire Arc Additively Manufactured AlSi5 Structures T2 - Metals N2 - For the purpose of this research, single track details were manufactured in the shape of thin walls with a length of 100 mm and a height of 80 mm. Two welding speeds were chosen for this experiment–13.3 mm/s and 20.0 mm/s corresponding to the following heat inputs: 120 J/mm and 80 J/mm. The gas metal arc welding (GMAW) method was used for the build-up of the specimens in the cold arc pulse mode. The structure of the specimens was studied using X-ray diffraction (XRD) analysis carried out with CuKα radiation with a wavelength of 1.5406 Ǻ, optical microscopy, scanning electron microscopy (SEM), and energy dispersive X-ray spectroscopy (EDX). Furthermore, the Vickers hardness of the samples was determined using a ZwickRoell DuraScan 10/20 G5 unit at a force of 1 N. A preferred crystallographic orientation towards the (200) plane was observed in all cases, however a vastly textured structure was observed with inclusions of peaks in the (111), (220), and (311) crystallographic planes. The full width at half maximum (FWHM) of samples taken from different stages of build-up was calculated indicating an increase of the dislocation density at the more advanced stages of specimen growth. Despite that an increase of the hardness was observed towards the top of both specimens. This is attributed to the change in the structure of the αAl + Si formations from an irregular one at the bottom of the specimens, towards a fibrous one at the top. The results are discussed in regard to the optimization of the build-up process during wire arc additive manufacturing (WAAM). KW - wire arc additive manufacturing KW - Al4043 KW - AlSi5 KW - heat input KW - microstructure KW - eutectic formations Y1 - 2022 SN - 2075-4701 VL - 12 IS - 11 ER -