TY - GEN A1 - Adelmann, Christoph A1 - Cuypers, Daniel A1 - Tallarida, Massimo A1 - Rodriguez, Leonard A1 - De Clercq, Astrid A1 - Friedrich, Daniel A1 - Conard, Thierry A1 - Delabie, Annelies A1 - Seo, Jin Won A1 - Locquet, Jean-Pierre A1 - De Gendt, Stefan A1 - Schmeißer, Dieter A1 - Elshocht, Sven van A1 - Caymax, Matty T1 - Surface Chemistry and Interface Formation during the Atomic Layer Deposition of Alumina from Trimethylaluminum and Water on Indium Phosphide T2 - Chemistry of Materials N2 - The surface chemistry and the interface formation during the initial stages of the atomic layer deposition (ALD) of Al2O3 from trimethylaluminum (TMA) and H2O on InP(100)were studied by synchrotron radiation photoemission spectroscopy and scanning tunneling microscopy. The effect of the ex situ surface cleaning by either H2SO4 or (NH4)2S was examined. It is shown that the native oxide on the InP surface consisted mainly of indium hydrogen phosphates with a P enrichment at the interface with InP. After a (NH4)2S treatment, S was present on the surface as a sulfide in both surface and subsurface sites. Exposure to TMA led to the formation of a thin AlPO4 layer, irrespective of the surface cleaning. The surface Fermi level of p-type InP was found to be pinned close to midgap after H2SO4 cleaning and moved only slightly further toward the conduction band edge upon TMA exposure, indicating that the AlPO4/InP interface was rather defective. (NH4)2S passivation led to a Fermi level position of p-type InP close to the conduction band edge. Hence, the InP surface was weakly inverted, which can be attributed to surface doping by S donors. TMA exposure was found to remove surface S, which was accompanied by a shift of the Fermi level to midgap, consistent with the removal of (part of) the S donors in combination with a defective AlPO4/InP interface. Further TMA/H2O ALD did not lead to any detectable changes of the AlPO4/InP interface and suggested simple overgrowth with Al2O3. Y1 - 2013 U6 - https://doi.org/10.1021/cm304070h SN - 1520-5002 VL - 25 IS - 7 SP - 1078 EP - 1091 ER - TY - CHAP A1 - Cuypers, Daniel A1 - Dorp, Dennis H. von A1 - Tallarida, Massimo A1 - Brizzi, Simone A1 - Rodriguez, Leonard A1 - Conard, Thierry A1 - Arnauts, Sophia A1 - Schmeißer, Dieter A1 - Adelmann, Christoph A1 - De Gendt, Stefan T1 - Study of InP Surfaces After Wet Chemical Treatments T2 - Meeting Abstracts-Electrochemical Society, San Francisco, 2013 KW - Synchrotron Radiation Photoelectron Spectroscopy KW - InP KW - Wet chemical treatment Y1 - 2013 UR - http://ma.ecsdl.org/content/MA2013-02/30/2132.full.pdf+html N1 - MA2013-02(30) SP - S. 2132 PB - The Electrochemical Society ER - TY - GEN A1 - Cuypers, Daniel A1 - Dorp, Dennis H. von A1 - Tallarida, Massimo A1 - Brizzi, Simone A1 - Rodriguez, Leonard A1 - Conard, Thierry A1 - Arnauts, Sophia A1 - Schmeißer, Dieter A1 - Adelmann, Christoph A1 - De Gendt, Stefan T1 - Study of InP Surfaces after Wet Chemical Treatments T2 - ECS Transactions N2 - In this work synchrotron radiation photoemission spectroscopy (SRPES) is used to study InP surfaces after different wet chemical treatments. All results are compared to a typical fingerprint of surface components present on an as received InP sample. It is shown that acidified (HCl and H₂SO₄) treatments efficiently remove the native phosphate, although components like Pᴼ, Inᴼ and P(2±∆)+ remain present. In alkaline solution (NH₄OH) oxide remains present at the surface. As an alternative treatment, the immersion into (NH₄)₂S was studied. This passivation treatment results in fewer surface components which suggests that a higher quality surface is obtained. KW - Synchrotron Radiation Photoelectron Spectroscopy KW - InP KW - Wet chemical treatment Y1 - 2013 U6 - https://doi.org/10.1149/05806.0297ecst SN - 1938-6737 SN - 1938-5862 VL - 58 IS - 6 SP - 297 EP - 303 ER - TY - GEN A1 - Cuypers, Daniel A1 - Dorp, Dennis H. von A1 - Tallarida, Massimo A1 - Brizzi, Simone A1 - Conard, Thierry A1 - Rodriguez, Leonard A1 - Mees, M. A1 - Arnauts, Sophia A1 - Schmeißer, Dieter A1 - Adelmann, Christoph A1 - De Gendt, Stefan T1 - Study of InP Surfaces after Wet Chemical Treatments T2 - ECS Journal of Solid State Science and Technology N2 - The influence of different wet chemical treatments (HCl, H₂SO₄, NH₄OH) on the composition of InP surfaces is studied by using synchrotron radiation photoemission spectroscopy (SRPES). It is shown that a significant amount of oxide remains present after immersion in a NH₄OH solution which is ascribed to the insolubility of In³⁺ at higher pH values. Acidic treatments efficiently remove the native oxide, although components like Pᴼ, Inᴼ and P(2±Δ)+ suboxides are observed. Alternatively, the influence of a passivation step in (NH₄)₂S solution on the surface composition was investigated. The InP surface after immersion into (NH₄)₂S results in fewer surface components, without detection of Pᴼ and P(2±Δ)+ suboxides. Finally, slight etching of InP surfaces in HCl/H₂O₂ solution followed by a native oxide removal step, showed no significant effect on the surface composition. KW - Synchrotron Radiation Photoelectron Spectroscopy KW - Scanning Tunneling Microscopy KW - InP KW - Wet chemical treatment Y1 - 2014 U6 - https://doi.org/10.1149/2.005401jss SN - 2162-8777 SN - 2162-8769 VL - 3 IS - 1 SP - N3016 EP - N3022 ER - TY - GEN A1 - Cuypers, Daniel A1 - Fleischmann, Claudia A1 - Dorp, Dennis H. von A1 - Brizzi, Simone A1 - Tallarida, Massimo A1 - Müller, Matthias A1 - Hönicke, Philipp A1 - Billen, Arne A1 - Chintala, Ravi A1 - Conard, Thierry A1 - Schmeißer, Dieter A1 - Vandervorst, Wilfried A1 - Elshocht, Sven van A1 - Armini, Silvia A1 - De Gendt, Stefan A1 - Adelmann, Christoph T1 - Sacrificial Self-Assembled Monolayers for the Passivation of GaAs(100) Surfaces and Interfaces T2 - Chemistry of Materials N2 - The use of sacrificial self-assembled monolayers (SAMs) to prepare clean n-type GaAs (100) surfaces without band bending in vacuo is demonstrated. GaAs surface passivation using octadecanethiol SAMs after HCl cleaning is shown to lead to an enhancement of the room-temperature photoluminescence intensity. Synchrotron-radiation photoelectron spectroscopy (SRPES) finds that the interfacial oxide between GaAs and the SAM remains below the detection limit. Evidence for both Ga–S and As–S bonds at the GaAs–thiolate interface is found. The limited thermal stability of the SAM allows the desorption of the alkyl chains by in situ thermal annealing at temperatures above 180 °C, leaving S bonded to Ga behind. The resulting surface contains only a very small amount of O (0.05 ML coverage) and C (about 3% of the SAM remaining) and shows no band bending with the surface Fermi level close to the conduction band. Atomic layer deposition of Al₂O₃ on this surface occurs via the formation of Al–S bonds without introducing any additional band bending. This indicates that the surface preparation of n-type GaAs (100) using sacrificial octadecanethiol SAMs followed by in situ thermal removal provides a route toward GaAs/oxide interfaces without interfacial oxides and without band bending. KW - GaAs KW - passivation KW - Al₂O₃ KW - atomic layer deposition (ALD) KW - Synchrotron-radiation photoelectron spectroscopy (SRPES) KW - self assembled monolayers (SAM) KW - interface engineering Y1 - 2016 U6 - https://doi.org/10.1021/acs.chemmater.6b01732 SN - 0897-4756 SN - 1520-5002 VL - 28 IS - 16 SP - 5689 EP - 5701 ER -