@inproceedings{MoradiLaunert, author = {Moradi, Milad and Launert, Benjamin}, title = {Welding induced stresses and deformation in tubes}, series = {BTU Stahlbau-Symposium 2014}, booktitle = {BTU Stahlbau-Symposium 2014}, publisher = {BTU}, address = {Cottbus [u.a.]}, pages = {91 -- 98}, language = {en} } @inproceedings{PasternakMoradiKrausche, author = {Pasternak, Hartmut and Moradi, Milad and Krausche, Thomas}, title = {Reconstruction of a school building in Wolfsburg, Germany}, series = {Tubular Structures XV, Proceedings of the 15th International Symposium on Tubular Structures, Rio de Janeiro, Brazil, 27-29 May 2015}, booktitle = {Tubular Structures XV, Proceedings of the 15th International Symposium on Tubular Structures, Rio de Janeiro, Brazil, 27-29 May 2015}, publisher = {CRC Press}, address = {Hoboken}, isbn = {978-1-138-02837-1}, pages = {31 -- 35}, language = {en} } @inproceedings{SimonMoradiHildebrandetal., author = {Simon, Flaviu and Moradi, Milad and Hildebrand, J{\"o}rg and Pasternak, Hartmut}, title = {The influence of the welding sequence on the load bearing capacity and stress distribution of square hollow section steel joints}, series = {Simulationsforum 2016, Schweißen und W{\"a}rmebehandlung, Weimar, Tagungsband 08.-10. November 2016}, booktitle = {Simulationsforum 2016, Schweißen und W{\"a}rmebehandlung, Weimar, Tagungsband 08.-10. November 2016}, editor = {Hildebrand, J{\"o}rg and Loose, Tobias and Reich, Michael}, publisher = {Verein zur F{\"o}rderung der numerischen Analyse der W{\"a}rmebehandlungs- und Schweißprozesse e.V.}, address = {Weimar}, isbn = {978-3-00-054805-5}, pages = {176 -- 187}, abstract = {The aim of this contribution is to investigate the influence of welding sequencing patterns on the load bearing capacity of a S355 steel square hollow section (SHS) T-Joint. The failure and the joint behavior under loading condition are analyzed. The FE-software SYSWELD v2014 is used for the thermo-mechanical simulation of the welding process. The type of welding process used is metal active gas (MAG) welding. A fillet weld with a throat thickness of 5 mm is performed. After the welding simulation, the results in terms of stresses and distortion are validated with the experimental data. Due to the geometrical characteristics of this type of joint, a compressive test is performed. A load is applied on the upper surface the vertical member (brace). The force-displacement behavior is plotted and discussed. The differences and influencing parameters are identified. The model is prepared for the subsequent sensitivity study which will be done in the software OptiSLang, which is developed by Dynardo GmbH.}, language = {en} } @misc{MoradiPasternak, author = {Moradi, Milad and Pasternak, Hartmut}, title = {A Study on the Influence of Various Welding Sequence Schemes on the Gain in Strength of Square Hollow Section Steel T-Joint}, series = {Journal of Welding and Joining}, volume = {35}, journal = {Journal of Welding and Joining}, number = {4}, issn = {2466-2232}, doi = {10.5781/JWJ.2017.35.4.7}, pages = {41 -- 50}, language = {en} }