@misc{KaiserSchenkEhrigetal., author = {Kaiser, Bert and Schenk, Hermann A. G. and Ehrig, Lutz and Wall, Franziska and Monsalve Guaracao, Jorge Mario and Langa, Sergiu and Stolz, Michael and Melnikov, Anton and Conrad, Holger and Schuffenhauer, David and Schenk, Harald}, title = {The push-pull principle: an electrostatic actuator concept for low distortion acoustic transducers}, series = {Microsystems \& Nanoengineering}, volume = {Vol. 8}, journal = {Microsystems \& Nanoengineering}, issn = {2055-7434}, doi = {10.1038/s41378-022-00458-z}, abstract = {Electrostatic actuators are of particular interest for microsystems (MEMS), and in particular for MEMS audio transducers for use in advanced true wireless applications. They are attractive because of their typically low electrical capacitance and because they can be fabricated from materials that are compatible with standard complementary metal-oxide semiconductor (CMOS) technology. For high audio performance and in particular low harmonic distortion (THD) the implementation of the push-pull principle provides strong benefits. With an arrangement of three electrodes in a conjunct moving configuration on a beam, we demonstrate here for the first time a balanced bending actuator incarnating the push-pull principle operating at low voltages. Our first design already exhibits a harmonic distortion as low as 1.2\% at 79 dB using a signal voltage of only 6 Vp and a constant voltage of only ±10 Vdc in a standard acoustic measurement setup. Thus, exceeding our previously reported approach in all three key performance indications at the same time. We expect that our novel electrode configurations will stimulate innovative electrostatic actuator developments for a broad range of applications. In this paper we report the basic theory, the fabrication and the performance of our novel actuator design acting as an audio transducer.}, language = {en} } @misc{MonsalveGuaracaoMelnikovStolzetal., author = {Monsalve Guaracao, Jorge Mario and Melnikov, Anton and Stolz, Michael and Mrosk, Andreas and Jongmanns, Marcel and Wall, Franziska and Langa, Sergiu and Marica-Bercu, Ioana and Br{\"a}ndel, Tim and Kircher, Marco and Schenk, Hermann A. G. and Kaiser, Bert and Schenk, Harald}, title = {Proof of concept of an air-coupled electrostatic ultrasonic transducer based on lateral motion}, series = {Sensors and Actuators A: Physical}, volume = {Vol. 345}, journal = {Sensors and Actuators A: Physical}, issn = {1873-3069}, doi = {10.1016/j.sna.2022.113813}, abstract = {An alternative implementation of an electrostatic MUT (Micromachined Ultrasonic Transducer), relying on multiple beams that displace along the chip's surface instead of a single membrane displacing perpendicular to it, is presented in this work. With this approach, a design requiring a low bias voltage (24 V) and occupying a small area (3.3×3.3 mm², 2D/λ≈0.77) was shown to generate a sound pressure level of 82 dB (re. 20 µPa-rms) at 40 kHz and a distance of 8.9 cm. The high level of damping allows this transducer to operate in a wide frequency range (35-63 kHz). The operation of this device as an ultrasonic receiver was also proven. An implementation of this transducer as a rangefinder requires a strong reduction in the noise level, particularly coming from radio-frequency interference, in order to increase its detection range.}, language = {en} }