@misc{GroenkeArroziBronkallaetal., author = {Gr{\"o}nke, Martin and Arrozi, Ubed S. F. and Bronkalla, Nadine and Schmidt, Peer and Valldor, Martin and Oswald, Steffen and Woodcock, Thomas G. and Eckert, Victoria and Hao, Qi and Pl{\"u}schke, Laura and Lederer, Albena and Nielsch, Kornelius and B{\"u}chner, Bernd and Kaskel, Stefan and Hampel, Silke}, title = {Layered α-TiCl₃: Microsheets on YSZ Substrates for Ethylene Polymerization with Enhanced Activity}, series = {Chemistry of Materials}, volume = {31}, journal = {Chemistry of Materials}, number = {14}, doi = {10.1021/acs.chemmater.9b01818}, pages = {5305 -- 5313}, abstract = {The transition metal halide α-titanium(III) chloride (α-TiCl₃) is a layered two-dimensional compound and a well-established Ziegler-Natta catalyst for the polymerization of ethylene. A new synthesis technique is used to obtain thin sheets of α-TiCl₃ that show exceptional physical properties in contrast to their bulk counterparts, due to an enlarged surface-to-volume ratio. Chemical vapor transport (CVT) of α-titanium(III) chloride directly on substrates results in microsheets that exhibit an improved catalytic effect. For rational planning of synthesis conditions, thermodynamic simulations of occurring gas-phase equilibria were performed. Based on these calculation results, crystal growth was achieved by adding GaCl₃via pure short term CVT in a temperature gradient of 700-600 K on yttrium-stabilized zirconia (YSZ) substrates. Phase pure, as-grown, single crystal sheets with high crystallinity and a thickness of around 4 μm were obtained. These thin sheets of α-TiCl₃ on YSZ substrates were implemented as catalysts for the ethylene polymerization reaction. A significant improvement of catalytic activity of 16\% was achieved, probably due to an increased surface-to-volume ratio. As a highlight, the as-grown microsheets were exfoliated subsequently to a thickness lower than 200 nm and an even higher catalytic activity of up to 24\% was confirmed experimentally due to delamination effects. This is the first time that an improved catalytic effect of α-TiCl₃ is observed as a result of downscaling from bulk to microsheets by CVT.}, language = {en} } @misc{GroenkeSchmidtValldoretal., author = {Gr{\"o}nke, Martin and Schmidt, Peer and Valldor, Martin and Oswald, Steffen and Wolf, Daniel and Lubk, Axel and B{\"u}chner, Bernd and Hampel, Silke}, title = {Chemical vapor growth and delamination of α-RuCl3 nanosheets down to the monolayer limit}, series = {Nanoscale}, volume = {10}, journal = {Nanoscale}, number = {40}, issn = {2040-3372}, doi = {10.1039/C8NR04667K}, pages = {19014 -- 19022}, abstract = {2D layered honeycomb magnet α-ruthenium(III) chloride (α-RuCl3) is a promising candidate to realize a Kitaev spin model. As alteration of physical properties on the nanoscale is additionally intended, new synthesis approaches to obtain phase pure α-RuCl3 nanocrystals have been audited. Thermodynamic simulations of occurring gas phase equilibria were performed and optimization of synthesis conditions was achieved based on calculation results. Crystal growth succeeded via chemical vapor transport (CVT) in a temperature gradient of 973 K to 773 K on YSZ substrates. Single crystal sheets of high crystallinity with heights ≤ 30 nm were obtained via pure CVT. The crystal properties were characterized by means of optical and electron microscopy, AFM, SAED, micro-Raman and XPS proving their composition, morphology, crystallinity and phase-purity. A highlight of our study is the successful individualization of nanocrystals and the delamination of nanosheets on YSZ substrates down to the monolayer limit (≤ 1 nm) which was realized by means of substrate exfoliation and ultrasonication in a very reproducible way.}, language = {en} } @misc{GroenkePohfleppSchmidtetal., author = {Gr{\"o}nke, Martin and Pohflepp, Danny and Schmidt, Peer and Valldor, Martin and Oswald, Steffen and Wolf, Daniel and Hao, Qi and Steiner, Udo and B{\"u}chner, Bernd and Hampel, Silke}, title = {Simulation and synthesis of alpha-MoCl₃ nanosheets on substrates by short time chemical vapor transport}, series = {Nano-Structures \& Nano-Objects}, journal = {Nano-Structures \& Nano-Objects}, number = {19}, issn = {2352-507X}, doi = {10.1016/j.nanoso.2019.100324}, pages = {1 -- 7}, abstract = {Alpha-molybdenum(III) chloride (MoCl₃) belongs to layered van-der-Waals materials, which are in focus to exhibit interesting properties due to their weak chemical and magnetic interactions. Especially the structure of alpha-MoCl₃ has been discussed in terms of symmetry breaking dimerization of Mo atoms at room temperature, which might led to exotic ground states. By exploiting the 2D materials characteristics, an investigation of physical properties on the nanoscale is intended. We herein demonstrate the probably first approach to synthesize phase pure, as-grown alpha-MoCl₃ few-layer nanosheets by means of a pure short time chemical vapor transport (CVT) process. Vapor growth benefits from a one-step deposition of high crystalline alpha-MoCl₃ nanosheets without stacking faults on a substrate. Thus, mostly applied subsequent delamination, associated with the introduction of structural defects, becomes redundant. According to the CVT process thermodynamic simulations of gas phase equilibria have been performed and the synthesis conditions could be optimized based on the calculation results. By CVT the as-grown nanolayers are deposited on sapphire (Al₂O₃) substrates by applying a temperature gradient of 70 K from 743 K to 673 K. Single crystalline sheets with thicknesses ≤75 nm down to five layer (3 nm) could be obtained by using a pure CVT process. According to the deposited nanostructures we approve the desired composition, morphology, phase purity and high crystallinity by using several microscopy and spectroscopy techniques. Furthermore, we show micro-RAMAN measurements which hint at a slight increase in phonon energies for nanosheets in comparison to the corresponding bulk phase.}, language = {en} } @misc{FroeschkeWolfHantuschetal., author = {Froeschke, Samuel and Wolf, Daniel and Hantusch, Martin and Giebeler, Lars and Wels, Martin and Gr{\"a}ßler, Nico and B{\"u}chner, Bernd and Schmidt, Peer and Hampel, Silke}, title = {Synthesis of micro- and nanosheets of CrCl3-RuCl3 solid solution by chemical vapour transport}, series = {Nanoscale}, volume = {29}, journal = {Nanoscale}, number = {14}, issn = {2040-3372}, doi = {10.1039/D2NR01366E}, pages = {10483 -- 10492}, abstract = {Solid solutions of 2D transition metal trihalides are rapidly growing in interest for the search for new 2D materials with novel properties at nanoscale dimensions. In this regard, we present a synthesis method for the Cr1-xRuxCl3 solid solution and describe the behaviour of the unit cell parameters over the whole composition range, which in general follows Vegard's law in the range of a = 5.958(6)CrCl3 … 5.9731(5)RuCl3 {\AA}, b = 10.3328(20)CrCl3 … 10.34606(21)RuCl3 {\AA}, c = 6.110(5)CrCl3 … 6.0385(5)RuCl3 {\AA} and β = 108.522(15)CrCl3 … 108.8314(14)RuCl3 °. The synthesized solid solution powder was subsequently used to deposit micro- and nanosheets directly on a substrate by applying chemical vapour transport in a temperature gradient of 575 °C → 525 °C for 2 h and 650 °C → 600 °C for 0.5 h as a bottom-up approach without the need for an external transport agent. The observed chromium chloride enrichment of the deposited crystals is predicted by thermodynamic simulation. The results allow for a nanostructure synthesis of this solid solution with a predictable composition down to about 30 nm in height and lateral size of several μm. When applying a quick consecutive delamination step, it is possible to obtain few- and monolayer structures, which could be used for further studies of downscaling effects for the CrCl3-RuCl3 solid solution. X-ray photoelectron spectroscopy, transmission electron microscopy and Raman spectroscopy were used to confirm the purity and quality of the synthesized crystals.}, language = {en} } @misc{GroenkeBuschbeckSchmidtetal., author = {Gr{\"o}nke, Martin and Buschbeck, Benjamin and Schmidt, Peer and Valldor, Martin and Oswald, Steffen and Hao, Qi and Lubk, Axel and Wolf, Daniel and Steiner, Udo and B{\"u}chner, Bernd and Hampel, Silke}, title = {Chromium Trihalides CrX₃(X = Cl, Br, I): Direct Deposition of Micro- and Nanosheets on Substrates by Chemical Vapor Transport}, series = {Advanced Materials Interfaces}, volume = {6}, journal = {Advanced Materials Interfaces}, number = {24}, issn = {2196-7350}, doi = {10.1002/admi.201901410}, pages = {11}, abstract = {The experimental observation of intrinsic ferromagnetism in single layered chromium trihalides CrX₃ (X = Cl, Br, I) has gained outstanding attention recently due to their possible implementation in spintronic devices. However, the reproducible preparation of highly crystalline chromium(III) halide nanolayers without stacking faults is still an experimental challenge. As chromium trihalides consist of adjacent layers with weak interlayer coupling, the preparation of ultrathin CrX₃ nanosheets directly on substrates via vapor transport proves as an advantageous synthesis technique. It is demonstrated that vapor growth of ultrathin highly crystalline CrX₃ micro- and nanosheets succeeds directly on yttrium stabilized zirconia substrates in a one-step process via chemical vapor transport (CVT) in temperature gradients of 100 K (600°C → 500°C for CrCl₃ and 650°C → 550°C for CrBr₃ or CrI₃) without a need for subsequent delamination. Due to simulation results, optimization of synthesis conditions is realized and phase pure CrX₃ nanosheets with thicknesses ≤25 nm are obtained via short term CVT. The nanosheets morphology, crystallinity, and phase purity are analyzed by several techniques, including microscopy, diffraction, and spectroscopy. Furthermore, a potential subsequent delamination technique is demonstrated to give fast access to CrX₃ monolayers using the example of CrCl₃ .}, language = {en} } @misc{MartinSuess, author = {Martin, Bernd and S{\"u}ß, Hendrik}, title = {Milnor algebras could be isomorphic to modular algebras}, language = {en} } @misc{MartinLavandoskyy, author = {Martin, Bernd and Lavandoskyy, Victor}, title = {A Symbolic Approach to Generation and Analysis of Finite Difference Schemes of Partial Differential Equations}, series = {arXiv.org : (math-ph)}, journal = {arXiv.org : (math-ph)}, pages = {24}, language = {en} } @misc{MartinHirsch, author = {Martin, Bernd and Hirsch, Tobias}, title = {Deformation with sections: Cotangent cohomology, flatnes conditions and modular germs}, series = {arXiv.org : (math.CV)}, journal = {arXiv.org : (math.CV)}, pages = {26}, language = {en} } @inproceedings{JantkeMemmelRostaninetal., author = {Jantke, Klaus-Peter and Memmel, Martin and Rostanin, Oleg and Thalheim, Bernhard and Tschiedel, Bernd}, title = {Decision Support by Learning-on-Demand}, series = {The 15th Conference on Advanced Information Systems Engineering (CAiSE '03), Klagenfurt/Velden, Austria, 16-20 June, 2003, workshops proceedings}, booktitle = {The 15th Conference on Advanced Information Systems Engineering (CAiSE '03), Klagenfurt/Velden, Austria, 16-20 June, 2003, workshops proceedings}, editor = {Eder, Johann}, publisher = {Techn. Univ.}, address = {Aachen}, isbn = {86-435-0552-8}, pages = {317 -- 328}, language = {en} } @misc{KuehhornBeirowSchrapeetal., author = {K{\"u}hhorn, Arnold and Beirow, Bernd and Schrape, Sven and Golze, Mark and Kn{\"o}pke, Martin}, title = {Simulation fluidged{\"a}mpfter Strukturschwingungen mittels partitionierter Fluid-Struktur-Kopplung}, series = {Forum der Forschung}, volume = {9}, journal = {Forum der Forschung}, number = {18}, issn = {0947-6989}, pages = {79 -- 86}, language = {de} }