@misc{WunderleMayHeilmannetal., author = {Wunderle, Bernhard and May, Daniel and Heilmann, Jens and Arnold, J{\"o}rg and Hirscheider, Josef and Lee, Yi and Bauer, J{\"o}rg and Schacht, Ralph and Abo Ras, Mohamad}, title = {Accelerated Pump Out Testing for Thermal Greases}, series = {20th International Conference on Thermal, Mechanical and Multi-Physics Simulation and Experiments in Microelectronics and Microsystems (EuroSimE)}, journal = {20th International Conference on Thermal, Mechanical and Multi-Physics Simulation and Experiments in Microelectronics and Microsystems (EuroSimE)}, publisher = {IEEE}, isbn = {978-1-5386-8040-7}, doi = {10.1109/EuroSimE.2019.8724540}, pages = {11}, abstract = {Thermal greases allow a low stress bond at low bond line thicknesses (BLT) at medium thermal conductivities and simple application, all of which make it an alternative to solders, thermal adhesives or pads. It is widely used in power and microprocessor applications, most of which involve large areas to be used for heat transfer. However, for years thermal overload failure of power modules and chips has been a pressing problem due to pump-out of thermal grease as a die or module thermal interface material (TIM): Most thermal greases are Bingham fluids and thus not solids, so they can be squeezed out from in between the gap, driven by thermo-mechanical action of the adjacent layers as e.g. DCB substrate or silicon chip with the heat sink. Today, thermal greases have to be qualified in lengthy stress tests in a product relevant environment which consumes substantial resources as often a system test is required. Therefore, a fast test is necessary which accelerates testing and thus allows a fast screening of commercial greases on one hand, and guidelines for material development on the other. For that purpose this paper addresses this topic in a combined simulative and experimental way, where at the same time a novel test procedure is proposed for accelerated grease pump-out testing (GPOT) in the framework of a completely new approach, combining loading with in-situ failure analytical techniques and decoupling thermal from mechanical loading. This allows for the first time a realistic loading of greases during accelerated testing with testing times below one hour. The method is demonstrated on various commercial and custom greases, varying their composition and structure, and benchmarked against industry standard thermal cycling tests. Further, two fundamental failure mechanisms have been identified being at work simultaneously, notably fluid transport (which constitutes actually a pump-in phenomenon) and air entrapment. We were able to identify key properties of the materials and loading variables, on which their intensity depends.}, language = {en} }