@inproceedings{HenkelDasSowinskaetal., author = {Henkel, Karsten and Das, Chittaranjan and Sowinska, Małgorzata and Tallarida, Massimo and Schmeißer, Dieter and Gargouri, Hassan and K{\"a}rkk{\"a}nen, Irina and Schneidewind, Jessica and Gruska, Bernd and Arens, Michael}, title = {Charakterisierung von TiO2-ALD-Schichten und deren Nutzung f{\"u}r die Passivierung von Si-Photokathoden}, series = {Tagungsband Photovoltaik-Meeting: Anwendungen-Qualit{\"a}t-Perspektiven, Senftenberg, 15.04.2015}, booktitle = {Tagungsband Photovoltaik-Meeting: Anwendungen-Qualit{\"a}t-Perspektiven, Senftenberg, 15.04.2015}, editor = {Gl{\"u}ck, B. K. and Schmidt, S. and Stein, E. and Raschke, J{\"o}rg-Uwe and Richter, H.}, publisher = {BTU Cottbus-Senftenberg}, address = {Senftenberg}, pages = {3 -- 8}, abstract = {Wir berichten zun{\"a}chst {\"u}ber den Einfluss der Methode der Atomlagenabscheidung auf die TiO2-Schichteigenschaften. Insbesondere wird der Zusammenhang zwischen Ti3+- sowie Interbandzust{\"a}nden mit elektrischen Kennlinien und deren Einfluss auf funktionale Schichteigenschaften diskutiert. Anschließend werden Mikrostrukturierung, Grenzfl{\"a}chen-Engineering und konforme Abscheidung einer TiO2-ALD-Schutzschicht effektiv zur Performance-Steigerung von p-Si-Photokathoden angewendet.}, language = {de} } @phdthesis{Das, author = {Das, Chittaranjan}, title = {Spectroscopic and electrochemical study of TiO2/Si photocathode}, url = {http://nbn-resolving.de/urn:nbn:de:kobv:co1-opus4-36924}, pages = {135}, abstract = {This thesis focuses on the deposition of thin TiO2 films on p-type Si using atomic layer deposition (ALD) technique, on the study of the electronic proprieties of the grown films and on the electrochemical characterization of TiO2/Si photoelectrodes. The deposition parameters, electronic properties and electrochemical performance and stability of the TiO2/Si samples are correlated. The ALD technique is used to deposit TiO2 with two different precursors namely Titanium isopropoxide and Titanium methoxide onto Si substrates. Laboratory as well as synchrotron based X-ray spectroscopy techniques are used to characterize these films. The growth quality of the TiO2 ALD films is determined by analyzing X-Ray photoelectron spectroscopy (XPS) data in terms of stoichiometry, defect states and Ti3+:Ti4+ ratios. The ALD technique was modified with different heating arrangements to obtain various polymorphs of TiO2. The ALD and anatase TiO2 films are characterized using synchrotron radiation to study their electronic properties and these films are compared with single crystal rutile TiO2. X-ray absorption spectroscopy (XAS) and resonant photoelectron spectroscopy (res-PES) measurements are performed with synchrotron radiation. XAS measurements are used to determine the polymorphs as well as the electronic structure of TiO2. Res-PES measurements are conducted at the O1s and Ti2p edges to study multiple hole Auger decay processes and polaronic and charge transfer states as well as to determine the electronic band gap of the TiO2 layers. One of the main findings of this thesis is the determination of the partial density of states (pDOS) of O and Ti in the conduction and valence band. The combination of the pDOS and the band edge positions obtained from res-PES measurements are used to calculate the charge neutrality level of the TiO2 polymorphs. The photoelectrochemical measurements are conducted on bare-Si and TiO2/Si photoelectrodes. The electrochemical performance of these photoelectrodes is studied in electrolytes having pH values ranging from 1 to 13. The deposition of TiO2 on Si enhances the photoelectrochemical performance of the Si photoelectrode. The TiO2 increases the stability of the photoelectrode in all electrochemical media over 12 hours of experimental condition. Moreover, it is also observed that the TiO2/Si photoelectrode is less responsive to the pH value of the electrolyte. The electrochemical findings are explained on the basis of the electronic properties of the TiO2 layer. The electronic band gap obtained from spectroscopic measurement and the photoelectrochemical measurements are used to explain the performance and stability of the TiO2/Si photoelectrodes. The thesis also addresses the stability of Si microstructured photoelectrodes (SiMPs) prepared by an electrochemical method. The stability of the SiMPs deteriorates more rapidly than that one of the planar Si photoelectrode. However, using a protective ALD TiO2 layer on these SiMPs the overall performance is even more enhanced than on the TiO2/planar Si system.}, language = {en} } @inproceedings{DasTallaridaSchmeisser, author = {Das, Chittaranjan and Tallarida, Massimo and Schmeißer, Dieter}, title = {X-ray linear dichroism in atomic layer deposited Titanium dioxide layers}, series = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, booktitle = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, publisher = {Deutsche Physikalische Gesellschaft}, address = {Bad Honnef}, issn = {0420-0195}, abstract = {Among the various metal oxides TiO2 has been investigated because of its wide range of applications in various fields such as self-cleaning, photocatalysis, solar cell, water splitting, bio-implants. In order to increase its efficiency in water splitting and solar cell energy conversion, it is necessary to understand the crystal structure and electronic properties of thin films. Generally the process of synthesis may modify the electronic properties of TiO2. In the present work we show X-ray linear dichroism (XLD) measurements of TiO2 thin films of different polymorphs. Titania thin films were produced by atomic layer deposition (ALD) and were characterized in-situ with X-ray photoelectron and absorption spectroscopy at synchrotron radiation center BESSY-II. We found that that all titania phases show XLD at Ti-L and O-K edges, but the intensity of XLD is different for different phases. We discuss our data in terms of the partial density of states.}, language = {en} } @inproceedings{DasTallaridaSchmeisser, author = {Das, Chittaranjan and Tallarida, Massimo and Schmeißer, Dieter}, title = {Control of thickness of SiO2 interfacial layer for photocatalytic water splitting on Si photocathodes}, series = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, booktitle = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, publisher = {Deutsche Physikalische Gesellschaft}, address = {Bad Honnef}, issn = {0420-0195}, abstract = {Silicon with a band gap of 1.1eV is an excellent candidate for visible photocatalytic water splitting. But p-type Si has a low quantum yield and are less efficient for water splitting [1]. It has been shown that preventing oxidation of Si surface can shift the onset potential for water reduction by about 300mV towards more positive [2]. We investigated in detail the influence of the SiO2 layer thickness on the onset potential for water splitting on Si photocathodes: we used p-type Si substrates covered with SiO2 layers of varying thickness. Then, we deposited a thin TiO2 film on using atomic layer deposition (ALD) to inhibit Si oxidation during the electrochemical experiment. In this way we could shift the onset potential up to 200mV, depending on the SiO2 thickness. [1]E. L. Warren, S. W. Boettcher, M. G. Walter, H. A. Atwater, and N. S. Lewis: J. Phys. Chem. C 115 (2011) 594. [2]B. Seger, Anders B. Laursen, P. C. K. Vesborg, T. Pedersen, O. Hansen, S. Dahl, I. Chorkendorff, Angew. Chem. Int. Ed. 2012, 51, 9128}, language = {en} } @inproceedings{DasTallaridaSchmeisser, author = {Das, Chittaranjan and Tallarida, Massimo and Schmeißer, Dieter}, title = {Determination of charge neutrality level in TiO2 films from res-PES measurements}, series = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, booktitle = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, publisher = {Deutsche Physikalische Gesellschaft}, address = {Bad Honnef}, issn = {0420-0195}, pages = {S. 415}, abstract = {Titanium dioxide is one of the metal oxides which have versatile application in different fields. The applications of TiO2 are in the field of cosmetics, electronics (memory resistive switching), dye, photonics and photocatalysis. In the present paper we study the resPES data of TiO2 films prepared by atomic layer deposition. The measurements are done in in-situ system at beam line U49/2-PGM2 in BESSY-II. The density of state in valence band and conduction band is obtained from the resonance photo electron spectroscopy (res-PES) of the O1s and the Ti2p edge. The data allow to determine the position of the VBM and CBM with respect to the Fermi energy. Also the existence of localized O2p and Ti2p derived states is deduced which appear in the gap. In addition we determine the charge neutrality level (CNL).The CNL is the position where the weight of the density of state from valence band and conduction band are equal. This is an important quantity for the discussion of interface properties.}, language = {en} } @inproceedings{DasTallaridaSkorupskaetal., author = {Das, Chittaranjan and Tallarida, Massimo and Skorupska, Katarzyna and Lewerenz, Hans-Joachim and Schmeißer, Dieter}, title = {An efficient Si photo cathode for a wide range of electrolyte pH values}, series = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, booktitle = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, publisher = {Deutsche Physikalische Gesellschaft}, address = {Bad Honnef}, abstract = {Hydrogen fuel cells, being environmental friendly to produce energy, are a technology of future. One of the efficient ways to produce hydrogen is solar driven photocatalysis using semiconducting materials as photo electrodes. The choice of electrodes is a crucial factor and is done on the basis of photo corrosion stability, light absorption efficiency, and photocarrier lifetime. P-type Si can be used as photo cathode to produce H2 by direct photocatalysis. Si cathodes can be used in acidic electrolytes to have efficient photo catalytic activity but they are unstable in alkaline electrolytes. Therefore, to use both Si electrodes in the same electrolyte, their chemical stability should be extended over a wide range of pH. To this purpose we modified the surface of a p-type Si photocathode with very thin films of TiO2 grown by atomic layer deposition (ALD). We found that the modified Si cathode shows an increased photoresponse and a lower onset potential with respect to the pristine surface and an increased stability at various pH values.}, language = {en} } @inproceedings{DasTallaridaSchmeisser, author = {Das, Chittaranjan and Tallarida, Massimo and Schmeißer, Dieter}, title = {TiO2 laminated Silicon microstructures based stable photocathode for water splitting}, series = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, booktitle = {Verhandlungen der Deutschen Physikalischen Gesellschaft}, publisher = {Deutsche Physikalische Gesellschaft}, address = {Bad Honnef}, pages = {S. 213}, abstract = {The photoelectrochemical (PEC) water splitting is one of the most efficient ways to obtain hydrogen from water using solar power which can be used as carbon free fuel. The PEC device can bedesigned using semiconducting material that will convert solar radiation to H2. Silicon can be one of the best choices for PEC due to its success in solar cells technology. There are certain issues with Si such as stability in electrochemical medium [1] and higher surface reflectance (25\%) which limits the Si as an ideal candidate for PEC technique [2]. In the present work we addressed these issues by surface structuring and laminating the surface with metal oxide. The microstructuring of Si was done by electrochemical method. The Si microstructure photocathode was stabilized by thin layer of ALD grown TiO2 film. The microstructuring and lamination of Si photocathode by ALD layer of TiO2 decreased the reflectance ofthe surface and shift the onset potential towards anodic direction by 350 mV with a prolonged stability over 60 hours[3]. [1] C. Levy-Clement, J. Electrochem. Soc 1991, 12, 69 [2] J. Oh, et al. Energy Environ. Sci., 2011, 4, 1690 [3] C. Das, et al. Nanoscale 2015,7, 7726}, language = {en} }